K.M Press Ltd., Part, Knowledge

รับแปรรูป - ขึ้นรูปโลหะแผ่น ด้วยแม่พิมพ์

Knowledge

How to maintain metal pressing machine?

-	In case of using pressing machine everyday, maintenance should be done as follows:
	1.	Apply grease every 4 hours in areas such as, 2 sides of crankshaft bushings, propeller crankshaft.
	2.	Lubricate both linear guide ways every 4 hours.
	3.	Always check oil level.
	4.	Apply grease on cogs every 15 days.
	5.	Check screws for loosening.

Is there any suggestion regarding how to operate pressing machine efficiently ?

-	Operating pressing machine efficiently is depending on many factors as below:
	1.	Check whether type of the work is suitable with capacity of metal pressing machine or not.
	2.	Mold must have sharpness so that it will not load capacity of metal pressing machine.
	3.	Care, clean, and always check lubricating system.


What are steps for installing mold onto metal pressing machine?

-	Operating pressing machine efficiently is depending on many factors as below:
	1.	Turn off metal pressing machine first.
	2.	Place mold on machine base.
	3.	Lower pressing head to the lowest position by turning pulley by hand and watch the scale on linear guide ways; it must be at the lowest position.
	4.	Lock mold to machine base and pressing head.
	5.	If mold is at too high or too low position, adjust at thread ball joint.
	6.	Set parallel of machine by adjusting screws for adjusting linear guide ways.
	7.	Once mold is installed, set pressing head at the highest position by turning pulley by hand.